
TxDOT: Oversized Loads Keep Hitting Texas Bridges, and Many Strikes Go Unreported
A Nov. 17 TxDOT report says oversized loads strike Texas bridges dozens of times a year, many hits go unreported, and the Houston Avenue bridge near I-10 has been struck six times this year.
A truck carrying an oversized load can do more than slow traffic when it hits a bridge. The impact can damage structural components, force lane closures and start a long repair, the Texas Department of Transportation said in a Nov. 17 report.
TxDOT records dozens of bridge strikes each year. The agency said the actual number is likely much higher than what is reported, because some impacts go unreported or are found only later during routine inspections.
In one example, the Houston Avenue bridge near Interstate 10 in Houston has been hit six times so far this year and 16 times since January 2025. The Fort Worth area had the most reported strikes last year, with eight.
Inspections are turning up still more damage that was not reported when it happened. TxDOT said it identified 30 instances of suspected unreported impact damage during routine bridge inspections in 2025, and another 61 instances in inspections completed so far in 2026. Because the damage may have occurred at any point since the previous inspection, the agency estimates that about 45 unreported strikes may have occurred in 2025. The Nov. 17 report does not give a single statewide total of reported strikes for 2026.
Permits, Routes and Who Pays
Bridge strikes typically occur when a truck or its load is taller than the clearance under a bridge, TxDOT said. The risk rises when drivers leave an approved route or travel without the required permits.
Vehicles and loads that exceed legal size or weight limits generally need an oversize or overweight permit and an approved route from the Texas Department of Motor Vehicles before they travel on state roads. Following that route matters, the agency said, because some roads and bridges are not built to take every oversized load.
When a driver is responsible for a strike, TxDOT said it can pursue a liability claim to recover taxpayer money spent because of the collision. The report does not say how many claims have been filed or how much has been recovered.
Once a strike is reported, crews first have to decide how badly the structure is damaged and whether it can stay open. In the Houston area, inspectors document the damage and share findings with local administrators and bridge engineers. Maintenance teams set traffic control, and engineers may use a bucket truck for a closer look.
“Engineers determine which bridge beams were damaged, the type and extent of the damage, and what repairs are necessary,” said Ryan Eaves, field operations section director in TxDOT’s Bridge Division. “Depending on the severity and location of the impact, TxDOT may close shoulders or additional lanes while crews assess the structure and develop a repair plan.”
Damaged concrete beams get special care. Crews remove loose concrete and may wrap the beam in chicken wire and a tarp to keep more concrete from falling onto traffic until a permanent repair can be made. For steel beams, crews also check any concrete connected to the bridge deck. On heavily traveled bridges, design and construction contracts have to move quickly, and repairs often happen at night or on weekends. TxDOT said those compressed schedules and specialized work can raise costs significantly, but it did not publish a statewide repair bill in the Nov. 17 report.
Warnings and One Bridge Being Rebuilt
Some districts have installed over-height detection systems that warn drivers when a vehicle or load is approaching a bridge with too little clearance. In the Odessa area, TxDOT has installed systems at 19 structures. The technology can help, the agency said, but only if drivers see the warning and act on it.
Where the same bridge keeps getting hit, TxDOT may try to strengthen or replace it or raise its clearance. The Houston Avenue bridge is tentatively scheduled for demolition beginning in early 2027, with completion estimated for mid-2028. The project would demolish and rebuild the bridge so the roadway runs underneath I-10, addressing the conflict with oversized and heavy truck traffic.
For commercial drivers, TxDOT’s advice is straightforward: know the vehicle’s height, get the proper permits and stay on the approved route. Those steps, the agency said, are how an avoidable collision is kept from becoming a closed lane, a damaged beam and a bill for the public.


